gefran SIEIDrive ADV100, Functions Description And Parameters List

Page: 86 / 172

86
ADV100 • Functions description and parameters list
22.3 – FUNCTIONS/MOTOR OVERLOAD
The overload control function provides integrator logic to protect the motor against thermal overload. This protection
presents the characteristic I²t behaviour and is an emulation of the thermal relay of the motor controlled by the ADV
drive.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
22.3.1 3200 Motor ovld enable BIT 0 0 1 ERW FVS
Enabling of the motor overload control.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
22.3.2 3202 Motor ovld factor perc FLOAT 150.0 100.0 300.0 ERWS FVS
Setting of the motor overload value. Percentage value of the motor rated current (par. 2002 Rated current ).
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
22.3.3 3204 Motor ovld time s FLOAT 30.0 10.0 300.0 ERWS FVS
Setting of the motor overload duration in seconds. It represents the moment in which the protection (“Motor Over-
load”) is enabled, if the motor current value is above the overload set in the Motor ovld factor parameter. This alarm
can be assigned to a programmable digital output ( Motor overload trip ).
The trip time depends on the motor current value and is as follows:
Motor ovld factor
Rated current
Trip time [s]
Motor current [%]
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
22.3.4 3206 Motor service factor perc FLOAT 100.0 25.0 200.0 ERWS FVS
Setting of the motor service factor. This is the difference between the peak current and rated current. It is used to
calculate the thermal image of the motor.