gefran SIEIDrive ADV100, Functions Description And Parameters List

Page: 103 / 172

ADV100 • Functions description and parameters list
103
23 – COMMUNICATION
23.1 - COMMUNICATION/RS232
The ADV100 drive is provided with a standard port (9 pole sub-D connector: XS) for connecting the RS232 serial line
used for drive-PC point-to-point communication (via the GF-eXpress configuration software).
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
23.1.1 3800 Drive address UINT16 1 1 255 ERW FVS
Setting of the address to which the drive responds when connected to the RS232 serial line.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
23.1.2 3802 Serial baudrate ENUM 38400 0 2 ERW FVS
Setting of the RS232 serial communication speed (Baud Rate).
0 9600
1 19200
2 38400
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
23.1.3 3810 Serial parameter ENUM None,8,1 0 3 ERW FVS
Setting of the format of the RS232 serial line.
0 None,8,1
1 None,8,2
2 Even,8,1
3 Odd,8,1
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
23.1.4 3804 Serial protocol ENUM Modbus 0 1 ERW FVS
Setting of the serial communication protocol:
0 Modbus
1 Jbus
Setting to 0 selects the Modbus RTU (Remote Terminal Unit) serial communication protocol.
Setting to 1 selects the Jbus serial communication protocol. The Jbus protocol is functionally identical to the Modbus,
except for the different numbering of addresses: in the Modbus these start from zero (0000 = 1st address) while in
the JBUS they start from one (0001 = 1st address) and maintain this difference throughout numbering.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
23.1.5 3806 Serial delay ms UINT16 0 0 1000 ERW FVS
Setting of the minimum delay between the drive receiving the last byte and starting its response. This delay avoids
conflicts on the serial line when the RS232 interface that is used has not been pre-set for automatic Tx/Rx switching.
The parameter only concerns the use of the standard RS232 serial line.
Example: if the delay in Tx/Rx switching on the master is a maximum of 20ms, the
Ser answer delay parameter
must be set to at least 20ms: 22ms
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
23.1.6 3808 Serial swap data BIT 0 0 1 ERW FVS
This parameter enables the exchange of the reading of the High and Low parts of the words for FLOAT type param-
eters when using the Modbus protocol.