gefran SIEIDrive ADV100, Functions Description And Parameters List

Page: 136 / 172

136
ADV100 • Functions description and parameters list
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3214 Motor overload trip BIT 16 0 0 1 ER
This signal is active when the drive is in the motor overload alarm condition.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3262 Bres overload trip BIT 16 0 0 1 ER
This signal is active when the drive is in the braking resistor overload alarm condition.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3342 Energysave out run BIT 16BIT 0 0 1 ER
This parameter is used to read whether an increase in output voltage or reduction in output voltage is being execut-
ed. This parameter may be linked to parameter 754 Ramp freeze src to freeze the speed ramp during changes in
output voltage.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3374 Vf catch out INT32 16 0 0 0 ER
The voltage applied during capture on-the-fly of the motor in Vf mode is displayed.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3442 Powerloss rampdown BIT 16 0 0 1 ER
This parameter indicates the status of the Powerloss function deceleration ramp
0 Powerloss function deceleration ramp not ended
1 Powerloss function deceleration ramp ended
The signal is enabled at the end of the Powerloss function deceleration ramp.
The signal is disabled at different times depending on the
Powerloss mode
setting.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3446 Powerloss nextratio INT32 32 0 0 0 ER
This parameter gives the ratio between the motor speed and the speed reference.
For machines with several drives, line synchronisation can be achieved by connecting the
Powerloss mode output
of the master to the Speed ratio src input of the slave drives. The master => slave connection can be achieved via
analog signals or fieldbus.
The value 2^30 corresponds to a ratio of 1.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3448 Powerloss nextactive BIT 16 0 0 1 ER
This parameter indicates the status of the Powerloss function
0 Powerloss not enabled
1 Powerloss enabled
The function is enabled when there is a power failure.
The function is disabled at different times depending on the
Powerloss mode setting.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
3480 Vdc ctrl ramp freeze BIT 16 0 0 1 ER
This parameter displays when the deceleration ramp block is requested during the Vdc control function .
0
VdcCtrl function not enabled