FujiFilm FRENIC5000G11S Series, Technical Information

Page: 71 / 236

2-23
Chapter 2
3. Function Explanation
2
ON
Frequency
detection
signal
Output frequency
Set frequency
Hysteresis width
Release level
Operation level
Time
This function outputs an early warning signal when heat sink
temperature is (overheat detection level - 10°C (50°F)) or higher.
Outputs ON signal when syncoronization is completed. (only
when an optional Synchronized Operation Card is used)
This function is same as Frequency detection [FDT1], the
detection level of the output frequency and hystersis width are
determined by E36 and E32.
This function outputs an ON signal when the output current
exceed “E37 OL2 LEVEL” for longer than “E35 OL TIMER”.
This function outputs an ON signal when the input current of
terminal C1 is less than 2mA.
This function output an ON signal when the motor speed is
detected. Only when using an optional card, OPC-G11S-PG/
PG2 or OPC-G11S-SY.
Settings when shipped from the factory
■
E25 Y5 RY operation mode
This function adetermaines the operation mode of Y5 relay.
- Set value 0: Inactive (Y5 relay excites at “ON signal” mode)
1: Active (Y5 relay excites at “OFF signal” mode)
■
E30 FAR function signal (Hysteresis)
This function adjusts the detection width when the output
frequency is the same as the set frequency (operating
frequency). The detection width can be adjusted from 0 to
±
10
Hz of the setting frequency.
- E30 Setting range: 0.0 to 10.0 Hz
When the frequency is within the detection width, an ON
signal can be selected and output from terminals Y1 to Y5.
■
E31 FDT1 function signal (Level)
■
E32 FDT1 function signal (Hysteresis)
This function determines the operation (detection) level of the
output frequency and hysteresis width for its operation
release. When the output frequency exceeds the set opera-
tion level, an ON signal can be selected and output from
terminals Y1 to Y5.
- Setting range Operation level : G11S: 0 to 400Hz
P11S: 0 to 120Hz
Hysteresis width : 0.0 to 30.0Hz
Overheat early warning [OH] : 28
Digital output Factory setting
Set value Description
Terminal Y1 0 Inverter running [RUN]
Terminal Y2 1 Frequency equivalence signal [FAR]
Terminal Y3 2 Frequency level detection [FDT1]
Terminal Y4 7 Overload early warning [OL1]
Terminal Y5 15 Auxiliary terminal (for 52-1) [AX]
E30 FAR HYSTR
ON ON
Time
Output frequency
+ Detection width
– Detection
width
+ Detection
width
Set frequency
Set frequency
- Detection
width
Frequency
detection
signal
E31 FDT1 LEVEL
E32 FDT HYSTR
2nd Freq. level detection [FDT2] : 31
2nd OL level early warning [OL2] : 32
Terminal C1 off signal [C1OFF] : 33
E25 Y5RY MODE
Synchronization completion signal [SY] : 29
Speed existence signal [DNZS] : 34
Chapter02J(P6˜25).p65
07.8.9, 12:26 Page 23
Adobe PageMaker 6.5J/PPC