FujiFilm FRENIC5000G11S Series, Technical Information

Page: 172 / 236

Chapter 5
1. Options
5-6
Type Card-type OPC-G11S-PG2
Unit-type –
Function To perform speed control by detecting motor rotating speed using a pulse generator.
Control
• No. of output pulse: 20 to 3000P/R A/B phase (incremental)
• Maximum response frequency: 100kHz
• Pulse output method: Line driver
Input
terminal
Output None
• Internal power source: +15Vdc
±
10%/200mA, (Terminal: PO, CM)*1)
• External power source: +5Vdc (
±
10%) to +15Vdc (+10%)/300mA or less *2) (Terminal: PI, CM)
*1) Use external power source when more than one PG feedback cards are used and the total input current
exceeds 200mA.
*2) Take note of the power source matches the specifications of the applied pulse generator.
Connection diagram
Remarks Terminals XA, XB, and XZ are not in use.
Name PG feedback card (PG power input : +5V)
Applicable
pulse
generator
Power
source
Specifica-
tions
YA, YB, CM Connect A- and B-phase output signal from pulse generator on feedback side
YZ, CM Connect Z-phase output signal from pulse generator on feedback side. When the
pulse generator does not have Z-phase, these terminals need not be connected.
Speed control range
1:1200 (3 to 3600r/min)
Maximum speed 3600r/min (120Hz)
Speed control accuracy
±
0.02%
Speed control response 40Hz
For the applicable motor,
see the combination list of inverter
and dedicated motor with PG.
J1
INT EXT
M
PG
L1/R
L2/S
L3/T
U
V
W
G
FRENIC
5000G11S
* Pin J2 can be connected to both 12V side and 15V side.
OPC-G11S-PG2 OPC-G11S-PG2
PI
J1
INT EXT
M
L1/R
L2/S
L3/T
U
V
W
G
FRENIC
5000G11S
When using inverter internal power source
1.
2. When using external power supply
5Vdc
±
10%
PO
YA
YA
YB
YB
CM
*
*
PG
PO
YA
YA
YB
YB
CM
*
*
PI
Chapter5-1(P1˜13).p65
07.8.9, 12:40 Page 6
Adobe PageMaker 6.5J/PPC