FujiFilm DR-ID 1300, Service Manual

Page: 4 / 628

0.2
0.2
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-02E
About Notation in the Manual

Notation of Warnings, Cautions, etc.
The notation formats of "warning," "caution," "instruction," "note," and "reference" are
shown below.
WARNING
Used when death or serious injury may occur if the instruction is not observed.
CAUTION
Used when minor or medium levels of physical injury may be incurred if the
instruction is not observed.
Also used when the machine may suffer serious trouble (such as unrecoverable
or difficult-to-recover trouble).
INSTRUCTION
Used when the machine may suffer damage, or any failure or malfunction may occur,
if the instruction is not observed.
NOTE
Used to indicate the matters that need attention during steps of the procedure.
REFERENCE
Used to indicate terminology or supplemental explanations.

Notation of Unit Symbols
For notation of unit symbols, metric units set forth in the International Systems of Units
(SI) are used, as a rule. However, metric units that are allowed in the Measurement
Law, not in the SI, are used in some cases.

Indication of Refer To
The " " mark is used to indicate the chapter or section you should refer to.
Its format is as indicated below.
{MC:1._Precautions for Check, Replacement, and Adjustment}

Notation in the Manual
This service manual may use the following notations.
Name Notation
Console Advance DR-ID 300CL, DX Console, Console, CL, CSL
Image Reader Unit RU
Flat panel sensor SE, Panel, FPD
RU PC-TOOL PC-TOOL

Notation of Symbols
- Check/Adjustment indicator: Indicates that it is necessary to check or adjust the
installation location when the part or component
removed is to be reinstalled. This indicator is placed in
CHECK
the illustration that depicts the procedures for removing/
installing the parts or components.
When you see this indicator in an illustration, see
"

Check/Adjustment Procedures" or "

CHECK" in a
later section.
- Half-punch indicator: Indicates that it is necessary to align the half-punches
when installing the parts or components. However,
it is not indicated for the half-punches for improving
ease of assembly or preventing erroneous assembly
procedures.
- 3B: Indicates that screw-locking bond needs to be applied
to screw sections of installed parts/components.
Recommended screw-locking bond: Three Bond 1401B