FujiFilm DR-ID 1300, Service Manual

Page: 61 / 628

Product Specifications
-16
Product Specification
-16
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-03E
10. Exposure Stand
REFERENCE
The exposure stand is not included in the machine components.
Use the exposure stand that meets the following requirements:
- An opening of D100 x H50 mm or larger can be provided at the center of the
external dimensions on the SE longitudinal side of the exposure stand, and the SE
LED must be able to be checked through this opening.
- An opening of D100 x H50 mm or larger can be provided approximately 200 mm
from the end opposite to the SE cable connector on the SE longitudinal side of the
exposure stand, and the SE LED must be able to be checked through this opening.
- There must be no risk that a finger of a patient is caught between the exposure
stand and the SE.
- The surface of the exposure stand where patients and operators will directly touch
must not be coarse and has no sharp edge.
- If the exposure stand is equipped with the external cover, display the panel effective
area and overlapping part on the top place of the exposure stand, with the center of
this top plate taken as the exposure center.
- If the exposure stand is equipped with the external cover, provide a fixed guide
within the exposure stand so that the center of the external dimension (exposure
center) of the SE matches the center of the top plate of the exposure stand (exposure
center).
Use the stand type exposure stand that meets the following requirements:
- The stand must be able to support the SE without causing it to fall down.
- When a patient leans against the stand, it must be able to support the SE.
- At the bottom surface of the SE for the exposure housing that supports the SE, the
lower limit detecting sensor must be installed.
- If the exposure stand is equipped without the external cover, the display of the panel
effective area and overlapping part must be able to be checked.
Use the bed type exposure stand that meets the following requirements:
- The SE surface is not used as applied part.
- The stand must not be broken with a patient weighing at least 135 kg on it.
- With a patient weighing at least 135 kg on it, the stand must be able to support SE.
- Even with a patient weighing at least 135 kg on it, no load must be directly applied
to the surface of the SE.