FujiFilm DR-ID 1300, Service Manual

Page: 416 / 628

IN1-35
IN1-35
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-04E
6.7 Reinstalling the Covers
(1) Reinstall the MP front cover, the rear cover and the top cover.
Reverse the removal procedures for reinstallation.
6.8 Fixing the Anchor (Optional)
(1) Make two marks on the floor by an oil-based marker or a center punch.
(2) Drill a hole on the two positions marked on the floor by the oil-based
pen, the center punch or the like.
u
INSTRUCTIONS
u
- Use a drill that is suitable for floor hole drilling.
- When drilling the anchor holes, take dust-preventive measures by a vacuum
cleaner or the like. If no vacuum cleaner is available, protect the machine
against dust by covering it with a plastic sheet.
- The anchor which is to be used when fixing is as per the following. In step 6,
adjust the depth of the hole so that the anchor is less than 14mm.
Part No.: SANKO TECHNO C-645
Anchor diameter: 6 mm, Pilot hole size: 6.4 mm, Length: 45 mm
(3) With a vacuum cleaner or like device, remove concrete chips and dust
from the drilled holes.
(4) Embed the anchors in the holes.
#1 Embed: Anchors (x2)
u
INSTRUCTION
u
Remove the cuttings that are stuck in the holes.
u
NOTE
u
The anchors corresponding to the anchor nut size should be prepared.
1200_700007.ai
#1
(5) Put the protruded section of the anchor through the fixing hole of the
bracket, and then place the bracket.
#1
1200_700157.ai
(6) Fix the bracket using anchor nuts.
#1 Fix: Anchor nuts (x2)
1200_700158.ai
Less than 14mm
(7) Place the MP with fixing bracket on the anchor-fixed bracket, and then
fix the MP at two locations on the front and the rear.
#1 Tighten: Screws (x4)
#1
1200_700155.ai