FujiFilm DR-ID 1300, Service Manual

Page: 29 / 628

Safety Precaution
-4
Safety Precaution
-4
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-02E
1.5 Cautions on Connection
Do not connect unspecified instruments.
1.5.1 Cautions on the MP Power Cable
The power cables which can be connected with the MP depend on the installation site.
<Japan>
Use supplied power cables.
Do not use other power cables.
<Outside Japan>
Use specified power cables.
Do not use other power cables.
Refer to the following section for the cable specifications.
{Spec:6._Electrical Specifications}
1.5.2 Cautions on the X-Ray Shot Cable
Measure the voltage between the cables connecting to the RDY1-RDY1 and the
RDY2-RDY2 terminals in all techniques before connecting the X-ray shot cable to the
terminal block of the AC bucky relay unit.
Check to make sure that the measured voltage conforms to the coil voltages (100/110
VAC, 110/120 VAC, 200/220 VAC and 220/240 VAC) of the relay to be used.
If the voltage between cables differs from the coil voltage of the relay, commission the
service personnel of the X-ray equipment to check the cable connection.
If erroneous connection is made, the machine might get damaged.
1.6 Cautions on the Table Tap and Extension
Cord
Do not use a table tap or an extension cord to supply the power to the system
components.