FujiFilm DR-ID 1300, Service Manual

Page: 132 / 628

MC-19
MC-19
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-02E
3. SE (Flat Panel Sensor)
WARNING
Never service the SE with the power supplied under any conditions.
Before servicing the SE, be sure to turn OFF the power of the machine or
disconnect the SE cable from the MP and the connection cable to shut the
power to the SE.
Otherwise, electrification, burn injury or short-circuiting might occur, resulting
in death or serious damage.
CAUTION
- Reserve a space which anyone other than service personnel cannot easily
access before servicing the SE in terms of assuring safety and performance.
- When servicing a board, be sure to wear a wristband to ground your body.
If your body is not grounded, static buildup on your body may damage
electronic components on the board.
- Never remove the ABA65A boards and GTD65A boards among the boards
mounted on the SE. Otherwise, the SE might break down and causing
abnormal images.
As the above boards cannot be removed, the flat cable connected with the
connector of the above boards cannot be disconnected, either.
- Do not scratch the ASIC mounted on the SE. Otherwise, abnormal images
might result.
ASIC
ASIC ABA65A board
1300_300002.ai
Flat cable
SE
u
INSTRUCTION
u
- Remove the SE cover where there is no dirt or dust around the machine.
- Follow the same procedures as those for installation when the SE is to be replaced
with a new one.