FujiFilm DR-ID 1300, Service Manual

Page: 244 / 628

MU1-79
MU1-79
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
1.9.11 Update SE FPGA
For the MC version V17.1 or later, if the fpgaRmv (FPGA) software shown below
(corresponding to MC V16.1) or earlier of the SE is upgraded, a message “The
selected SE does not support this function.” appears, resulting in failure of upgrade of
the FPGA software.
Panel fpgaRMV (FPGA) software
DR-ID 1201SE 0 x 0080
DR-ID 1202SE 0 x 00A0
DR-ID 1211SE 0 x 00B0
DR-ID 1212SE 0 x 00B0
DR-ID 1213SE 0 x 00B8
DR-ID 1214SE 0 x 00C8
If the FPGA version of the SE is earlier than these, use “Upgrading the SE FPGA” to
install an in-between version of FPGA software.
1200_400134.ai
(2)
(3)
(1)
(1) Click “UTILITY” - “Update SE FPGA”.
The Update SE FPGA window opens.
(2) Select the target SE from the drop-down list box.
(3) Click [START].
The SE’s CPU version is upgraded, and the implementation results are displayed
on the pop-up screen.
(4) Click [OK].
u
INSTRUCTION
u
After the above is completed, manually upgrade the SE software version via the
following procedures.
{MU1:1.1.2_Update SE}