FujiFilm DR-ID 1300, Service Manual

Page: 114 / 628

MC-1
MC-1
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
1. Precautions for Check,
Replacement, and Adjustment
- In this volume, descriptions are omitted regarding components that do not require
special attention or adjustment during their removal/reinstallation. For removal
procedures for such components, refer to the Service Parts List Volume.
- When performing check/replacement/adjustment procedures on the machine, the
following precautions should be observed.
WARNINGS
l
To avoid electric shock hazards, power OFF the machine before performing
the procedures.
l
Wear safety shoes for operation.
WARNING/CAUTION
Observe the warnings and cautions described in the "Safety Precautions".
CAUTIONS
- When servicing a board, be sure to wear a wristband to ground your body.
If your body is not grounded, static buildup on your body may damage
electronic components on the board.
- When servicing a board, do not apply force to the center of the board or bend
the board while holding both sides of the board. If the board is bent or force
is applied to its center, a crack may occur on a soldered connection, resulting
in a failure in its connection.
- When servicing a board, do not touch connector pins mounted on the board
with bare hands.
- Never remove the red-painted screws.
u
INSTRUCTIONS
u
- The yellow-painted screws require adjustments when components are reinstalled.
When reinstalling the components, follow the check/adjustment procedures.
- Safety provided by grounding is assured by properly establishing power cable and
additional protective ground wire connections and securing the parts with retaining
screws. To maintain safety, ensure that the parts and retaining screws removed
for servicing purposes are restored to states existing upon installation. After the
parts and retaining screws are restored to the above-mentioned states, follow the
procedures set forth in this Service Manual to verify that the retaining screws are
securely tightened to properly secure the parts.
- Do not leave an object which might cause damage on the SE (Flat Panel Sensor)
(such as a tool, a screw or a removed component). If the SE gets scratched,
abnormalities in image might result.
- Do not drop the SE nor apply a load larger than specified onto the exposure plane.
{Operation Manual: Precautions}
u
INSTRUCTION
u
Exercise care not to make a radius of curvature of the SE cable smaller than 50
mm when handling the SE cable. If the radius of curvature is smaller than 50 mm,
disconnection might occur in the cable, resulting in abnormality in image.
u
NOTE
u
Photos used for describing the procedures or the like in the manual may sometimes
appear to be different from the actual machine.
REFERENCE
The following characters are used as abbreviations to express colors of cables or the
like.
Abbreviation Color Abbreviation Color
RED Red ORN Orange
WHT White GRY Gray
BLK Black YEL Yellow
GRN Green BLU Blue
BRN Brown PUR Purple
Y/G Spiral of yellow and green