Flavor Burst CTP 80CBB, Equipment, Maintenance And Operations Manual

Page: 51 / 80

50
NOTE: YOUR HANDS SHOULD BE CLEANED
AND SANITIZED BEFORE YOU PERFORM
THE FOLLOWING PROCEDURES.
NOTE: INSPECT ALL WEAR ITEMS AND
REPLACE IF NECESSARY.
NOTE: THE FOLLOWING PROCEDURES
REQUIRE APPROVED, SERVICEABLE AND
SANITIZED TOOLS AND BRUSHES.
CONTACT YOUR LOCAL DISTRIBUTOR FOR
RECOMMENDED SUPPLIES.
NOTE: USE AN APPROVED CLEANER AND
SANITIZER FOR THE FOLLOWING
PROCEDURES. REFER TO
MANUFACTURER’S INSTRUCTIONS FOR
PROPER PREPARATIONS OF THESE
CLEANING AGENTS.
NOTE: THE SYSTEM IS NOT TO BE USED
BY PERONS (INCLUDING CHILDREN) WITH
REDUCED PHYSICAL, SENSORY OR
MENTAL CAPABILITIES, OR LACK OF
EXPERIENCE AND KNOWLEDGE, UNLESS
THEY HAVE BEEN GIVEN SUPERVISION OR
INSTRUCTION.
NOTE: CHILDREN ARE TO BE SUPERVISED
WHEN USING THE SYSTEM AND SHALL
NOT PLAY WITH THE SYSTEM.
NOTE: INSTALL THE SYSTEM WHERE
AMBIENT TEMPERATURES ARE BETWEEN
60 AND 80 DEGREES FAHRENHEIT FOR
CORRECT OPERATION.
NOTE: INSTALL THE SYSTEM IN A
LOCATION WHERE ITS USE AND
MAINTENANCE IS RESTRICTED TO
TRAINED PERSONNEL.
Installing the Touch Panel and Mounting
Bracket
The Touch Panel is the control unit for the
Flavor Burst
® system. Normal operating
functions are performed using the Touch Panel
and the freezer draw handle. The Touch Panel
is mounted to the top of the freezer with the
Touch Panel mounting bracket.
1. Prepare detergent water by mixing several
drops of Dawn
®
dish soap with a gallon of
warm water (108°F / 42°C).
2. Clean the top surface of the freezer
between the front edge and the hopper with
warm detergent water. Rinse the area with
warm water (108°F / 42°C) and dry with a
single service towel. This area is where the
Touch Panel will be mounted.
NOTE: THE SURFACE MUST BE FREE
FROM DUST AND OILS OR THE ADHESIVE
WILL NOT CURE PROPERLY.
3. Use the ampule provided to prime the
cleaned area before mounting the Touch
Panel mounting bracket. Pinch the primer
ampule at the dot on the tube to release the
primer fluid into the brush end. Apply the
primer (acetone) to freezer area where the
mounting bracket will be attached. Allow the
primer to dry completely before proceeding.
NOTE: LIQUID INSIDE THE AMPULE
ENHANCES ADHESION.
EQUIPMENT SETUP