Flavor Burst CTP 80CBB, Equipment, Maintenance And Operations Manual

Page: 28 / 80

27
6. The following do not need to be sanitized on
a daily basis as part of the daily opening
procedures. However, inspect these areas
and if necessary, clean according to
instructions in the SCHEDULED
MAINTENANCE section:

9-Tube Assembly Coupler

9-Tube Assembly Tubes

Touch Panel and Mounting Bracket

Drive Motor

Exposed surfaces of Cabinet
Assembling the Blending Assembly
The two Blending Head o-rings and the Gear
Cartridge are wear items and will need to be
replaced periodically. Check for wear
occasionally and always keep spares of these
items on hand in the Spare Parts Kit.
1. Place the Gear Cartridge into the Drive
Assembly Gear Box so that the gear teeth
line up with the gear inside the Drive
Assembly Gear Box.
2. Install the Blending Head onto the Drive
Assembly Gear Box and rotate off-center to
secure.
3. Insert the Drive Motor into the Drive
Assembly Gear Box so that all four locking
screws are seated properly and rotate the
motor clockwise to secure.
4. Install the o-rings in their proper positions
on the adapter body.
NOTE: DIFFERENT ADAPTERS HAVE
DIFFERENT SETS OF O-RINGS / GASKETS.
REFER TO THE BLENDING ASSEMBLY
DIAGRAM AT THE BEGINNING OF THIS
MANUAL FOR MORE INFORMATION ON THE
ADAPTER YOU ARE USING AND ITS PARTS.
26025