Flavor Burst CTP 80CBB, Equipment, Maintenance And Operations Manual

Page: 52 / 80

51
4. Measure and mark with a pencil the center
of the freezer within that cleaned area.
Measure and mark the center of the base
plate of the mounting bracket assembly.
5. Remove the protective covering from the
adhesive strip on the bottom of the base
plate. The front of the plate is the side with
the posts that are closest together. Line up
the center of the plate with the center mark
on the freezer. Apply the base plate to the
freezer. Press firmly and allow the adhesive
to cure
for at least 1 hour
.
NOTE: IF THE ADHESIVE DOES NOT HAVE
TIME TO CURE PROPERLY, THE CONSTANT
WEIGHT OF THE TOUCH PANEL CAN PULL
THE ADHESIVE AWAY FROM THE FREEZER
SURFACE. THIS COULD EVENTUALLY
RESULT IN THE TOUCH PANEL ASSEMBLY
FALLING OFF THE FREEZER.
6. The mounting bracket may already be
attached to the Touch Panel. If it is not,
install the Touch Panel mounting plate to
the back of the Touch Panel using the
screws provided. Use the small lock
washers in between the plate and screws.
7. Connect the ethernet cable to the “DRIVER
BOARD 1” ethernet port behind the Touch
Panel screen.
NOTE: WHILE “DRIVER BOARD 2” PORT IS
ALSO A VALID PORT, IT IS TEMPORARILY
PLUGGED TO AVOID CONFUSION. THE
COLOR TOUCH PANEL PROGRAM
DEFAULTS TO DRIVER BOARD 1.
8. Connect the straight end of the switch
extension to the “PORT 1” switch port
behind the Touch Panel screen.
NOTE: WHILE “PORT 2” SWITCH PORT IS
ALSO A VALID PORT, IT IS TEMPORARILY
PLUGGED TO AVOID CONFUSION. YOU
WILL ACTIVATE THE PORT YOU USE WHEN
YOU GO THROUGH THE EQUIPMENT
SETUP WIZARD PROGRAM ON YOUR
COLOR TOUCH PANEL LATER.
9. Place the anchor bracket within the arms of
the Touch Panel plate so that the flat end of
the anchor bracket extends away from the
front of the Touch Panel.