Generator Failure
22.3.11
Panda_AGT-DC_5000_12V_s01285_Operation manual.R03 - Chapter 7: Generator Failure Page 111
7.2.4 Fuse on control panel board
It is possible that the fuse on the control
circuit board of the control panel is defec-
tive. Replace the fuse if it is defective.
01. Fuse on control panel board (630 mA,
slow-blow)
Fig. 7.2.4-1: Panel back side
7.2.5 Failure Bypass Switch
The start-failure bypass switch enables an immediate restart facility of the generator, should it cut
out, even if this was caused by over-heating. There is normally a requirement to wait until the
motor has cooled down to the correct temperature. This can last for several hours in certain cir-
cumstances, since the generator is enclosed in a sound-insulated casing, which prevents heat
loss.
Failure bypass switch
Fig. 7.2.5-1: Failure bypass switch
01
