FibroLAN Falcon Gen-3 M-Class, User Manual

Page: 320 / 473

Falcon M-Class | User Guide
320
4.22.4.4 Functional Configuration
Figure 4-180: Functional Configuration
Table 4-164 : Functional Configuration Parameters
Continuity Check
Enable
Continuity Check based on transmitting/receiving CCM PDU can be
enabled/disabled. The CCM PDU is always transmitted as Multi-cast Class 1.
Priority
The priority to be inserted as PCP bits in TAG (if any). In case of enable of
Continuity Check and Loss Measurement both implemented on SW based CCM,
'Priority' has to be the same.
Frame rate
Selecting the frame rate of CCM PDU. This is the inverse of transmission period
as described in Y.1731. This value has the following uses:
* The transmission rate of the CCM PDU
* Fault Cause cLOC is declared if no CCM PDU has been received within 3.5
periods - see 'cLOC'.
* Fault Cause cPeriod is declared if a CCM PDU has been received with different
period - see 'cPeriod'
Selecting 300f/sec or 100f/sec will configure HW based CCM (if possible).
Selecting other frame rates will configure SW based CCM. In case of enable of
Continuity Check and Loss Measurement both implemented on SW based CCM,
'Frame Rate' has to be the same.
TLV Enable/disable of TLV insertion in the CCM PDU.
TLV : is an acronym for T ype L ength V alue. A LLDP frame can contain multiple
pieces of information. Each of these pieces of information is known as TLV.
APS Protocol
Enable Automatic Protection Switching protocol information transportation based on
transmitting/receiving R-APS/L-APS PDU can be enabled/disabled. Must be
enabled to support
ERPS /ELPS implementing APS. This is only valid with one
Peer MEP configured.
Priority The priority to be inserted as PCP bits in TAG (if any).
Cast Selection of APS PDU transmitted unicast or multi-cast. The unicast MAC will be
taken from the 'Unicast Peer MAC' configuration. Unicast is only valid for L-APS -
see 'Type'. The R-APS PDU is always transmitted with multi-cast MAC described
in G.8032.
Type R-APS: APS PDU is transmitted as R-APS - this is for ERPS.
L-APS: APS PDU is transmitted as L-APS - this is for ELPS.
Last Octet This is the last octet of the transmitted and expected RAPS multi-cast MAC.
In G.8031 (03/2010) a RAPS multi-cast MAC is defined as 01-19-A7-00-00-XX.
In current standard the value for this last octet is '01' and the usage of other
values is for further study.
Buttons Fault Managemen t: Click to go to Fault Management page
Performance Monitoring : Click to go to Performance Monitor page.
Refresh : Click to refresh the page immediately
Save: Click to save changes
Reset: Click to undo any changes made locally and revert to previous saved