Festo MPA-FB Series, Manual

Page: 37 / 168

2. Fitting
2−7
Festo P.BE−MPA−EN en 0502b
Variants Fastening possibilities
1 1
MPA valve terminal with CPX
terminal
2
Hole for hat rail
clamping units:
1
in the end plates
2
in the pneumatic interface
1
MPA valve terminal with MP or MPM connection
2
Hole for hat rail
clamping units:
1
in the MP sub−base
2
in the right−hand end plate
Table2/2: Holes for the hat rail clamping unit
Fitting Proceed as follows:
1. Make sure that the fastening surface can support the
weight of the MPA valve terminal (weights see appendix
A, TableA/1).
2. Fit the hat rail (support rail EN 60715 − 35x7.5; width 35
mm, height 7.5 mm). Make sure there is sufficient space
for connecting the cables and the compressed air supply
tubing.
3. Fasten the hat rail to the fastening surface at intervals of
approx. every 100 mm.