Festo MPA-FB Series, Manual

Page: 137 / 168

5. Diagnosis and error treatment
5−41
Festo P.BE−MPA−EN en 0502b
Necessary components
For extension you will require:
Components MPA valve terminal with ...
CPX terminal MPM connection
One sub−base per:
MPA1: 4 valve locations
MPA2: 2 valve locations
VMPA1−FB−AP−...
VMPA2−FB−AP−...
One electronic module per sub−base VMPA..−FB−EM−... VMPA..−MPM−EMM−...
Valve plates or blanking plates:
MPA1: 4 per sub−base
MPA2: 2 per sub−base
VMPA..−M1H−...
VMPA..−M1H−...
If necessary, additional supply unit
with exhaust plate
with large surface−mounted silencer
VMPA..−FB−SP
VMPA..−FB−SPU
For each sub−base or supply unit added the ap
propriate manifold
boards:
manifold board for sub−base
manifold board for supply unit
VMPA1−FB−EV−AB
VMPA1−FB−EV−V see section "Overview
of manifold boards"
Table5/13: Valve location extension
Removing Proceed as follows:
1. Loosen the MPA valve terminal from the fastening surface
(see section Dismantling the MPA valve terminal").
2. Dismantle the sub−base or supply unit at the point where
you wish to extend the valve terminal (see section 5.3.5).
3. MPA valve terminal with MPM connection:If you wish to fit
a further sub−base after the last sub−base in front of the
right−hand MPA end plate, you must remove the end piece
type MPA from the last manifold board.