Festo MPA-FB Series, Manual

Page: 138 / 168

5. Diagnosis and error treatment
5−42
Festo P.BE−MPA−EN en 0502b
1
End piece
Type MPA
1
Fig.5/17: Removing/fitting the end piece of the last manifold board
Fitting Proceed as follows:
1. Fit the new sub−base and, if applicable, a further supply
unit (see section 5.3.5).
2. Only MPA valve terminal with MPM connection:
If the sub−base added is the last one in front of the right−
hand end plate, you must insert the end piece type MPA
into the last manifold board (see diagram Fig.5/17).
3. Fit the valve plates or blanking plates onto the empty
valve locations (see section 5.3.3).
4. Fit the MPA valve terminal onto the fastening surface (see
chapter 2 "Fitting onto a wall" or "Fitting onto a hat rail").
5. Then fit the pneumatic and electrical connections (see
chapter 3 "Installation, connecting the MPA valve ter
minal").
Please note
If a sub−base is inserted between existing sub−bases, the
address assignment of all the valves to the right of the
inserted sub−base will be shifted.