Festo MPA-FB Series, Manual

Page: 39 / 168

2. Fitting
2−9
Festo P.BE−MPA−EN en 0502b
1
Hat rail
2
Clamping
element of the
hat−rail clamping
unit
1
2
Fig.2/2: Rear view: Fitting the CPX terminal onto a hat rail
Further instructions on fitting the MPA valve terminal with
CPX terminal onto a hat rail can be found in the CPX system
manual.
Removing Proceed as follows:
1. Loosen the locking screw of the hat rail clamping unit
(position of the screws see Table2/2). Make sure that the
clamping element lies horizontally to the hat rail.
2. Swing the MPA valve terminal forwards away from the hat
rail (see Fig.2/3).
3. Lift the MPA valve terminal away from the hat rail (see
Fig.2/3).