EWS UFS8000, Operating Manual, Page: 97 / 130

UFS8000 Modbus 90
Decimals:
Number of decimals
21.1.3. Register : others
40097
Proces ID 1
40098 Sub process nr 1
40099 Sub process description id 1 sec.
40100 Remaining time of sub process 1
40101-02 Service / Filtration counter 2 min.
40103-04 Remaining time until maintenance 2 min.
40105 CEB 1 : remaining number of backwashes until CEB 1 1
40106-07 CEB 1 : remaining time until CEB 1 2 min
40108 CEB 2 : remaining number of backwashes until CEB 2 1
40109-10 CEB 2 : remaining time until CEB 2 2 min
40111 CEB 3 : remaining number of backwashes until CEB 3 1
40112-13 CEB 3 : remaining time until CEB 3 2 min
40150 Alarm reset
Register 40097 : Process ID
The current process will be indicated by a number. In the table below you will find the corresponding
process description.
1
Standby 7 Standby stop
2 Filtration 8 Alarm state
3 Backwash 9 Backwash 2
4 CEB 1 10 Pre flush
5 CEB 2 11 CEB 3
6 Integrity test 12 Filtration 2 (top)
Register 40098 : Sub Process ID
The number of the sub process will be indicated.
Register 40099 : Sub Process description ID
The description id of the sub process will be indicated.
For the pre flush and CEB’s the following descriptions ID’s are defined :
1
Air Scour 8 Air Scour 2
2 Air Scour 1 9 Drain 2
3 Drain 10 Dosing 1
4 Drain 1 11 Dosing 2
5 Backwash 1 12 Permeate dump 1
6 Backwash 2 13 Permeate dump 2
7 Soak 14 Forward Flush
255 Number of sub process will be shown
For the integrity test the following description ID’s are defined :
22
Drain
23 Pressurizing
24 Test
254 Wait
Register 40100: Remaining time of sub process
The remaining time for the current sub process will be indicated (in seconds).
Register 40150 : Alarm Reset
This register can be written with a random value. When an alarm relay was activated so this will be
deactivated.