
UFS8000
Manual operation of the unit
57
9. Manual operation of the unit
The unit can be controlled manually.
The main menu's “Manual control” features an overview of the manual
operations possible at that time.
The options for each phase are shown below.
9.1. Standby stop
During the “Standby Stop” phase the unit is at a standstill and is not activated
until the unit is manually switched on. This window can be used to switch on
the unit.
9.2. Integrity test
The “Integrity test” phase can be divided into “non-active” status and “active” status.
During “non-active” status the following actions can be applied:
- Start actual integrity (active status) via “Start integrity”
- Quit integrity via “Exit integrity”
You return to the Standby phase.
During “active” status only this status can be stopped (“Stop integrity”).
9.3. Standby
Various actions can be applied during the “Standby ” phase.
- Start production via “Start installation”
This option is not displayed if the unrefined water tank is empty, or the filtration stop that
depends on the position of the level switches of the storage tank when the storage tank is full,
or if the filtration start is dependent on the input “Filtration start” mode and this input is not
active.
Summary of Contents for UFS8000
