Epson Equity 386/25, User Manual

Page: 220 / 326

6. Remove the four screws securing the hard disk drive
mounting plate to the hard disk drive. Then remove and
store the mounting plate along with the screws.
7. Wrap the hard disk drive in its original packing materials
and set it aside. Then carefully arrange the power supply
cable so that it fits down into the vertical mounting area.
Make sure that the cable does not interfere with any other
cables or mechanisms.
8.
Follow the steps on page 5-30 to replace the computer’s
cover. Then see “Post-installation Setup” later in Chapter 5
for instructions on configuring your computer for use
without a hard disk drive.
Note
After you change your computer’s drive configuration, your
computer may take up to five minutes to complete power-on
diagnostics the next time you turn it on.
Installing or Removing a Disk Drive in the
Horizontal Position
This section describes how to install or remove a hard disk drive
or a diskette drive in the lower horizontal drive bay. You can use
these same instructions if you need to install a different diskette
drive in the upper drive bay; however, the illustrations show the
lower bay.
If you are installing a second hard disk or diskette drive, you
must install it in the lower horizontal drive bay. Your first
diskette drive is in the upper bay and your first hard disk is in
the vertical mounting position beside the drive bays.
Installing and Removing Disk Drives
B-27