Epson EB-G6800, User Manual

Page: 21 / 173

Make sure there is a gap of at least 50 cm between the wall and the air
exhaust vent and the air intake vent.
Air exhaust vent
Air intake vent
When setting up multiple projectors, make sure there is a gap of at least
50 cm between the projectors.
When installation is complete, set the Direction from the configuration
menu according to the vertical installation angle.
Attention
Make sure you set Direction correctly. The lamp's operating life may be
reduced if it is not set.
a
Press the [Menu] button while projecting.
b
Select Direction from Extended .
c
Use the [ ][ ] buttons to set the projector's installation angle.
Each time you press one of the buttons, the angle of tilt changes by
15 degrees. Set as close to the actual setup angle as possible.
d
When you have finished making settings, use the [ ] button to
select Set , and then press the [ ] button.
Changing the direction of the image (projection mode)
You can change the direction of the image using
Projection
mode from the
Configuration menu.
s
Extended
-
Projection
p.91
Installing the Projector
21