Emerson Rosemount 2240S, Reference Manual, Page: 58 / 194

48
Reference Manual
00809-0100-2240, Rev DA
Configuration/Operation
October 2017
Configuration/Operation
5.2 Introduction
This chapter provides information about configuration of the Rosemount
™
2240S Multi-input
Temperature Transmitter regardless of the configuration tool used. However, you will find frequent
references to TankMaster WinSetup, which is the recommended configuration tool.
It is important that configuration is properly prepared by listing the appropriate Modbus addresses,
device tags, and tank tags.
5.2.1 Configuration procedure
Basically, a Rosemount 2240S can be installed and configured by one of the following methods:

As part of the installation of a Rosemount 2410 Tank Hub. This is the standard procedure when a new
system is installed, see the Rosemount Tank Gauging System Configuration Manual .

As a separate device, connected to the Tankbus of a Rosemount 2410 in an existing Rosemount Tank
Gauging system. The device is configured with a suitable tool, such as TankMaster WinSetup.

As a separate device in a F
OUNDATION
™
fieldbus system. AMS Device Manager may be used for
configuration.
5.2.2 Parameters
Temperature elements
The basic configuration includes parameters for a standard configuration which is sufficient in most
cases. The following parameters are configured:

number of temperature elements

temperature element type (Spot or Average)

position in tank

temperature elements excluded from average calculation

minimum distance between element and product surface for element to be included in average
temperature calculation (insert distance)
Water Level Sensor
Configuration of the water level sensor includes:

level offset (difference between tank zero level and water zero level)

probe length

upper and lower dead zone