87
Basic settings in the Control Center
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
Manual menu:
Shows whether the safety module is displayed in the manual menu and in the start
menu. Touch the field and make your selection.
Default setting: Display in manual mode "Yes", in start menu "No".
The display in the start menu is below the menu items "System" and "Manual menu".
The display sequence and other representation options can be set in the menus
System > Set screen > Start page or manual menu
5.2.4. Start page, Page 84
5.2.5. Manual page, Page 85
Live switching:
Touch the field to configure the live switching of the safety module.
Switching delay external:
Set the live switching delay here if a detector is installed in the entrance area. As a re-
sult, you have time to leave the house during the delay before the detectors in the en-
trance area are live.
This delay time only applies to external live switching (e.g. via an absence button or
the door lock), not if you set the alarm at the control center.
Alarm delay:
Set the alarm delay here. If a detector is triggered in the entrance area, for which a de-
lay has been set, the alarm is only reported after the end of this time.
Display activation acknowledgement:
This is where you set how long the message, which has been successfully activated, is
displayed and at the same time a "1" is sent to the KNX bus.
Display error message:
This where you set how long an error message is displayed if activation failed.
Deactivation code for external live:
If desired, specify a code here for deactivating the external live switching.
Alarm:
Touch the field to set how an alarm is reported.
Signal message duration:
Activation duration of external signal flashing light:
This is where you set how long an external flashing light remains on after an alarm.