113
Automatic
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
If
No
is selected, set the position using the slider. 0% = horizontal, 100% = closed. De-
fault setting: 75%.
If
Yes
is selected, sun position tracking is active. Set the slat position for the four pre-
defined sun angles.
Default setting: 0° to 15°: 100% (closed), 15° to 30°: 75%, 30° to 45°: 50%, 45° to 90°: 0%
(horizontal).
Sensor selection:
Shows the indoor sensor, which is evaluated for controlling the shades. Touch the field
and select a sensor.
Default setting: No sensor.
If no sensor is selected, the indoor temperature is not taken into account for the con-
trols of the shading.
Indoor temperature:
Shows the setting for the indoor temperature block. The setting is only active if an in-
door sensor is selected. Touch the field to adjust the indoor temperature block.
Select
OFF
if the shading should depend on the indoor temperature (default setting).
Change to
ON
to set the desired temperature.
Default setting: 25.0 °C.
By using the indoor temperature block, the sun's energy is used to heat the room. If the
indoor temperature is below the set value, e.g. in the morning, then the shades remain
retracted despite the sun.
As soon as the set indoor temperature is exceeded, the lock is lifted and the shades re-
leased.
If the indoor temperature decreases, the block is activated as soon as the temperature
is more than 3.0°C below the set value (hysteresis). Note that the shades are not retract-
ed until the retraction delay time has expired.
System > Set automatic > General settings > Movement delays
6.3.2. Adjust movement delays (shades), Page 106
Night closing:
Shows whether the shades are extended or not at night. Touch the field and switch the
night closing on or off.
The limit value, from which twilight/night is detected, can be adjusted.
System > Set automatic > General settings > Twilight
6.3.1. Adjust twilight value, Page 105
