33
Installation and commissioning
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
• Comply with the locally applicable directives, regulations and provisions for
electrical installation.
• Immediately take the device or system out of service and secure it against
unintentional switch-on if risk-free operation is no longer guaranteed.
Use the device exclusively for building automation and observe the operating instruc-
tions. Improper use, modifications to the device or failure to observe the operating in-
structions will invalidate any warranty or guarantee claims.
Operate the device only as a fixed-site installation, i.e. only in assembled condition and
after conclusion of all installation and operational start-up tasks, and only in the sur-
roundings designated for it.
Elsner Elektronik is not liable for any changes in norms and standards which may occur
after publication of these operating instructions.
3.1.4. Safety information about automatic and
alarm functions
WARNING!
Risk of injury from automatically moving components!
System parts may start automatically as a result of the automatic
controls and can put people in danger.
•
People must not enter the movement range of
motorised moving parts.
•
If staying outside the building, make sure that the return
path/access is not blocked (danger of being locked out).
•
During maintenance and cleaning work, switch off
the system.
Rain alarm for automatically controlled windows:
If rain is entering, it may be some time before rain is detected by the sensors in the sys-
tem, depending on the amount of rain and outside temperature. In addition, a closing
time for electric windows or sliding roofs has to be included in the calculation. Mois-
ture-sensitive objects should therefore not be placed in areas where thy could be dam-
aged by entering precipitation.
Icing-up of rails of the shades:
Be aware that the rails of blinds, awnings and shutters, which are fitted outside, can ice
up. If a motor is then moved, shades and motors can be damaged.
Power outage, maintenance work, etc.
If there is a power outage or bus voltage failure, no commands, safety or protection
functions (e.g. secure position in there is a wind or rain alarm) can be executed in the
KNX system! If the full extent of functions is also to be guaranteed if the mains power
