64
Basic settings in the ETS
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
You may enter separate set point values for each mode or use the comfort set point as
a basic value.
Setpoint Comfort
Comfort mode is usually used for daytime mode when people are present. A temper-
ature range is defined for the comfort set point, in which the nominal value may be
modified.
If setpoints are set separately:
If the comfort set point value is used as a basis:
If the comfort value is used as the basis, the increase/reduction of this value is stated.
Setpoint Standby
Standby mode is usually used for daytime mode when people are absent.
If setpoints are set separately:
Type of control
• Single stage heating
• Dual-stage heating
• Single-stage cooling
• Single-stage h single-stage cool-
ing
• Dual-stage h single-stage cooling
• Dual-stage h dual-stage cooling
Setting the setpoints
• separately
• with comfort set point as a basis
Evaluation of the status object
• 0 = Heating | 1 = Cooling
• 1 = Heating | 0 = Cooling
Switching object value
before first Communication
(
only if switching object is used
)
0 • 1
Min. object value heating/cooling (in 0.1 °C)
-300…800; 160
Max. object value heating/cooling (in 0.1
°C)
-300…800; 280
Minimum object value (in 0.1°C)
-300…800; 160
Maximum object value (in 0.1°C)
-300…800; 280
Reduction by up to (in 0.1°C)
1…100; 50
Increase by up to (in 0.1°C)
1…100; 50
Min. object value heating/cooling (in 0.1 °C)
-300…800; 160
Max. object value heating/cooling (in 0.1
°C)
-300…800; 280
