23
Operation
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
A
motor
can be precisely positions by briefly pressing it (less than 1 second, short au-
dio signal). For blinds and shutters, only a brief step movement command is issued. If
the button is held for more than 1 second (same audio signal: state signal), the motor
moves automatically to the end position. Briefly pressing the opposite direction stops
the motor.
For shades and windows, the movement position is shown in percent above the Up-/
Down buttons (for blinds, also the slat position).
Automatic lock / manual / automatic
Whether a motor or device is in automatic mode or has been operated manually, can
be detected from the blue marking on the key and the text in the list on the left. You
can switch mode by pressing a key.
After any manual operation, the drive or unit remains in manual mode. The automatic
functions are then switched off, only rain and wind protection are executed. The re-
spective automatic mode can be reactivated by hand ("Auto" button) or for all motors
and devices ( Building on automatic:, Page 85). In addition, an automatic reset can be
activated in the automatic settings of each motor group and each device, both at a fixed
time and after a manual operation. You can access these and other settings of a drive/
unit directly with the "Automatic Settings" button.
Pressing the "Auto block" button pauses the automatic system (blue button font).
Pressing it again ends the automatic mode pause (text on the button white).
Info icons
Alongside position and status information, icons on the manual page show how auto-
matic mode is currently working and whether there is a block, which inhibits manual
operation for example.
Icon GREY: Function has been set up in the automatic menu but is not currently active.
Icon WHITE: Function is active.
Icon RED: Alarm active.
Block by the rain, wind or frost alarm
If there is a
frost alarm
, the icon for the button is identified by a surrounding. Press
the button for approx. 1 second in order to release manual operation. The frost lock will
then only be active for this drive again when it is reactivated manually or the next time
the frost alarm is triggered.
If a motor group should currently be locked for manual oper-
ation by rain or frost alarm, no up/down arrows are displayed.
The red icons show the alarm for the relevant motor groups.
