Elsner 71200, Installation, Setting, Operation

Page: 114 / 148

112 Automatic
CasaConnect KNX Control Center • Version: 13.09.2021 • Technical changes and errors excepted.
tion of the shades if the light conditions are rapidly alternating. The movement delays
can be adjusted.
System > Set automatic > General settings > Movement delays
6.3.2. Adjust movement delays (shades), Page 106
Sun direction:
Shows the area (direction of the sky) where the sun must be so that the shade is
opened. Touch the field to set the direction of the sun. The setting is only active if shad-
ing is deployed depending on the brightness.
Use the keys to select: from All sides , West , South-West , South , South-East or
East . Or enter the angle range numerically in °.
Default setting: All sides.
As long as no time signal is received and the time has not been set manually ("Please
set time" is displayed on the start page), shades are only controlled depending on light
intensity, temperature and alarm messages, the sun position is not considered.
Sun height:
Shows the area (height above the horizon) where the sun must be so that the shade is
opened. Touch the field to set the angle using a slider. The setting is only active if shad-
ing is deployed depending on the brightness.
Default setting: 0-90°.
As long as no time signal is received and the time has not been set manually ("Please
set time" is displayed on the start page), shades are only controlled depending on light
intensity, temperature and alarm messages, the sun position is not considered.
Actuation position shading:
Shows the actuation position in percent for automatic mode. Touch the field to set the
position using a slider. 0% = fully retracted, 100% = fully extended.
Default setting: 100%.
Select whether a reference run is to be carried out before the shading position.
If No is selected, the shade moves directly to the set position.
If Yes is selected, the shade first retracts completely and then moves to the set posi-
tion.
Slat position (only blinds):
Shows the behaviour of the slats in automatic mode. Touch the field to adjust the set-
ting.
Select whether the slats should follow the sun.