28/76
MP120
where “yy” indicates whether the event is correlated (YES) or not (NO).
8. Use button ▼ to select the event you wish to associate or not, then press
ENTER
.
9. “YES” or “NO” will blink: make you choice by means of button ▼, then confirm by pressing
ENTER
.
10. If you do not wish to change the type of connection or sending, go to step 13; otherwise, press
ESC
, then press
ENTER
and, finally, ▼: the last letter will blink (“v”, “f” or “n”).
11. Press
ENTER
: the following message will appear on the display:
where “xxxxx” indicates the type of connection or sending to be used (vocal, remote-control or numeric).
12. Press
ENTER
again, then use button ▼ to choose from among “Vocal”, “Numeric” and “Remote-control”.
Confirm your choice by pressing
ENTER
, then press
ESC
.
13. Repeat the procedure starting from step 8 for all the events to be correlated or eliminated, or press
ESC
several
times to exit the menu.
2.14.3 EVENT PRIORITY
In the event that several events occur simultaneously, the event with the highest priority level will take precedence
when sending the messages through the telephone. “0” indicates the highest priority, whereas “7” indicates lowest
priority. The same priority level may be assigned to different events; if several events with the same priority level
occur simultaneously, the order of precedence will be the following: Theft, Tampering, Robbery, Panic,
Technological, Fire, Failure, Status Change.
To modify the predefined priority levels (refer to paragraph
5.8 TELEPHONE ALARM CHANNEL EVENTS
),
proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press ▼ until the message below appears:
Then press
ENTER
to confirm.
4. The following message will appear on the display:
where “n” indicates the priority level for the highlighted event.
5. Use button ▼ to select the event you wish, then type in the new priority level (any digit 0 to 7).
6. Repeat the procedure starting from step 5 to modify the priority level for the other events, or press
ESC
several
times to exit the menu.
E V : B u r g l a r y P : n
E v e n t P r i o r i t y
P h o n e N u m b e r P R G
C o m m u n i c a t o r P R G
E v e n t M e m o r y
C a l l T y p e x x x x x
A L : B u r g l a r y - > y y