22/76
MP120
To modify it, press
ENTER
and use button ▼ to choose another type, then confirm by pressing
ENTER
.
12. WARNING! IF THE OUTPUT IS NOT OF THE “Break-in”, ”Sector TC” OR “SYS Status” TYPE, GO TO STEP
14. Press ▼. The list of the sectors to which the output is correlated will appear on the display:
To modify it, press
ENTER
and then type in the numbers of the sectors to be correlated (by typing in the number
of a sector already correlated, its correlation will be eliminated: the dash indicates a non-correlated sector). To
correlate it to all the sectors, press
TOTAL
. End the procedure by pressing
ENTER
.
13. Press ▼. The AND/OR condition for the output operation sectors will appear on the display:
To modify it, press
ENTER
and choose the desired one by means of button ▼, then confirm your choice by
pressing
ENTER
.
14. Press ▼. The output level will appear on the display:
To modify it, press
ENTER
and select the level by means of button ▼, then confirm your choice by pressing
ENTER
.
15. Press
ESC
to go up one level in the menu.
16. Press ▼ to go to the next output to be configured (start again from step 11) or press
EXIT
to exit the menu.
2.9 KEYS
The MP120 system may use two different actuation/deactivation keys: electronic key DK20 (with the DK2000M
inserter) and transponder key DK30 (with the DK3000M inserter).
2.9.1 DK20
The MP120 system can manage up to 16 DK20 keys, each with a unique code. Key features:
•
an identification label up to 8 characters long (e.g. the user’s name) may be matched to each key;
•
the key may be disabled, if necessary;
•
the sectors to be controlled may be freely correlated to each key;
•
the key is re-programmable, i.e. the identification code may be changed at any time. The code is chosen
randomly by the control unit during programming.
Refer to paragraph
3.11 KEYS
for DK20 key programming and configuration.
2.9.2 DK30
The MP120 system can manage up to 16 DK30 keys, each with a unique factory-set code that cannot be changed
(over 280,000 billion combinations are possible). Key features::
•
an identification label up to 8 characters long (e.g. the user’s name) may be matched to each key;
•
the key may be disabled, if necessary;
•
the sectors to be controlled may be freely correlated to each key.
Refer to paragraph
3.11 KEYS
for DK30 key programming and configuration.
2.10 LPA PROGRAMMING
To configure the list of the events recognized by the LPA outputs, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
E v e n t M e m o r y
0 2 : L v . : N . L O W
0 1 : a / o : O R S E C T
0 2 : S e t . : 1 2 3 4 5 6 7 8
0 2 : B u r g l a r y O H
Example
