55/76
MP120
Press ▼ until the following message appears on the display:
where “x” may refer to “A” or “B”. Confirm by pressing
ENTER
.
4. Use button ▼ to select mode “0”, then press
ENTER
to confirm.
5. Press
ESC
several times to exit the menu.
3.4 MODIFYING THE ACCESS CODE
Warning!
If you are modifying the Master code through the “Master” menu, press
ENTER
to confirm and then go
right on to step 3 of the procedure.
Each user may change the received access code with another code of their own choice. To modify an access
code, proceed as follows:
1. type in the access code to be modified, then press
ENTER
to confirm.
2. Press
C**
. The following message will appear on the display:
3. Type in the new access code, the length of which shall be 3 to 7 digits, then press
ENTER
to confirm. The new
code shall start with the same initial digit as the previous code (e.g. if the previous code is 333333, the new
code shall be 3...). Each entered digit is represented by an asterisk on the display.
4. The following message will appear on the display:
Type in the new code again for checking, then press
ENTER
to confirm.
5. If the two entered codes match each other, the new code will replace the older one, and the buzzer will beep
twice to confirm that the operation has been carried out successfully. Otherwise, an error signal will be emitted,
and the procedure will be exited.
6. Press
ESC
to leave the procedure.
3.5 DATE CHANGE
To modify the data, proceed as follows:
1. type in the Master code or the Installer code, then press
ENTER
twice.
2. The following message will appear on the display:
Press ▼ until the following message appears on the display:
where “dd-mm-yy” indicates the date currently stored in the memory, then confirm by pressing
ENTER
.
3. The following message will appear on the display:
4. Type in the new date in the day-month-year form, by using two digits for each value to be entered (the last two
digits represent the year; if either the day or month consist of only one digit, the latter shall be preceded by “0”,
e.g. “05”), then press
ENTER
to confirm. If the date is valid, the buzzer will beep twice and the date will be
stored. Otherwise, the beep sound will be longer and the display will show «SetDATE dd-mm-yy» again.
5. Press
EXIT
to leave the procedure.
S e t D A T E d d - m m - y y
S e t D A T E d d - m m - y y
E v e n t M e m o r y
R e e n t e r N e w C o d .
E n t e r N e w C o d e
C a l l B a c k - x -
A c c e s s o d a T E L N
R e m o t e C o n t . S
