56/76
MP120
3.6 TIME CHANGE
To modify the time, proceed as follows:
1. type in the Master code or the Installer code, then press
ENTER
twice.
2. The following message will appear on the display:
Press ▼ until the following message appears on the display:
where “hh-mm” indicates the time currently stored in the memory, then confirm by pressing
ENTER
.
3. The following message will appear on the display:
4. Type in the new date in the hour-minute form, by using two digits for each value to be entered, then press
ENTER
to confirm. If the time is valid, the buzzer will beep twice and the time will be stored. Otherwise, the
beep sound will be longer and the display will show «Set TIME hh:mm» again.
5. Press
EXIT
to leave the procedure.
3.7 EVENT MEMORY READING
The MP120 control unit stores in its memory the latest 250 events occurred. The following information is stored for
each event: sequence number (the lower the number, the more recent the event), type of event, name of
concerned input (if applicable), event description (if applicable), event date and time.
3.7.1 REFERRING TO THE EVENT MEMORY
To refer to the event memory file, proceed as follows:
1. type in the Master code or the Installer code, then press
ENTER
twice.
2. The following message will appear on the display:
Confirm by pressing
ENTER
.
3. The most recent event will appear on the display:
where “xxxxxxxxxxx” represents the short description of the event. Use buttons ▼ and ► to select the other
events.
4. Press
ENTER
to refer to the event-specific events.
5. Press
ENTER
to know the event date and time.
6. By pressing
ENTER
again, you will go back to the short event description.
7. Press
EXIT
to leave the menu.
0 0 1 x x x x x x x x x x x
E v e n t M e m o r y
S e t T I M E h h : m m
S e t T I M E h h : m m
E v e n t M e m o r y
