61/76
MP120
The following tables sum up the
“DTMF CONTROLS”
to be used:
ON /OFF
310 #
311 #
OFF Sect. 1
ON Sect. 1
320 #
321 #
OFF Sect. 2
ON Sect. 2
330 #
331 #
OFF Sect. 3
ON Sect. 3
340 #
341 #
OFF Sect. 4
ON Sect. 4
350 #
351 #
OFF Sect. 5
ON Sect. 5
360 #
361 #
OFF Sect. 6
ON Sect. 6
370 #
371 #
OFF Sect. 7
ON Sect. 7
380 #
381 #
OFF Sect. 8
ON Sect. 8
300 #
301 #
TOTAL OFF
TOTAL ON
SYSTEM STATUS REQUEST
0 #
After 5 seconds
the voice synthesis will list the
ON / OFF status, 230V mains and battery
status.
IF
present, Failure, Alarm and Tampering
status will be listed.
HANG UP CURRENT CALL:
* #
Communication ended
3.9.2 BYPASS ANSWER
If an answering machine is available on the telephone line used by the control unit, a higher number of answering
rings than the one set for the answering machine shall be programmed in the control unit. Moreover, the “Jump”
function shall be enabled (refer to paragraph
2.14.7 Telephone options
).
In this case, you may get connected to the control unit and perform remote control as follows:
1. call the telephone number of the line to which both the control unit and the answering machine are connected.
2. Wait for the third answering ring.
3. End communication.
4. Allow 5 seconds to elapse, then call back the telephone number: after the first ring, the MP120 control unit will
answer the incoming call. WARNING! The wait time before calling back shall not exceed 30 seconds; otherwise,
the procedure shall be repeated starting from step 1.
5. Perform remote control as described in paragraph 3.9.1 REMOTE CONTROL PROCEDURE.
3.10 POSTPONING AUTOMATIC SYSTEM ACTUATION
During pre-actuation, i.e. during the 5 minutes preceding the automatic actuation of the antitheft system by the time
programmer, such actuation may be postponed by 1 hour ONLY ONCE. The pre-actuation time will be signalled by
the keyboards through the buzzer sound, the P.O. LED blinking, and the «Pre-actuation» message appearing on
the display. During this phase, the outputs programmed as “Pre-actuation” will be actuated too.
To postpone, i.e. delay, the automatic actuation of the antitheft system, type in a user code through the keyboard
during the pre-actuation time.
