32/76
MP120
Press ▼ until the message below appears:
where “xxxxxxxx” is a sequence of dashes and letters that summarize the enabled options (with the aforesaid
abbreviations); then, confirm by pressing
ENTER
. The following message will appear on the display:
where “xx” indicates the selection mode currently set.
4. Select the parameter to be modified by means of button ▼, then press
ENTER
to confirm.
5. The value assigned to the parameter will blink on the display. Press ▼ to change this value, then confirm your
choice by pressing
ENTER
. Correct memorization of the new setting will be signalled by a double beep.
6. Repeat the procedure starting from step 4 if you wish to modify other parameters, or press
ESC
several times to
exit the menu.
2.14.8 TELEPHONE LINE CHECK
The MP120 control unit may check the presence of the control unit tone on the telephone line to which it is
connected, in order to make sure that the connection is operating perfectly; if this is not the case, the MP120
control unit will send an alarm signal. WARNING! If the control unit is the first unit of the telephone line (as
recommended), each line check will cause any telephone in progress to be interrupted.
Possible settings for the “Line check” function include:
•
No
, i.e. no check will be carried out to verify that the telephone line is available.
•
24-h
, i.e. the telephone line availability check will always be carried out, every 15 minutes, even when the
system is OFF.
•
ON partial (OnPart)
, i.e. the telephone line availability check will be carried out when the system status
changes and then every 15 minutes, only with the antitheft system ON, even in a partial way.
•
ON total (OnTot)
, i.e. the telephone line availability check will be carried out when the system status changes
and then every 15 minutes, only with the antitheft system fully ON.
For each of the four settings you may also establish whether, in addition to the signals on the display and the
memorization on the event memory file, the outputs programmed as “Tampering” will also be actuated in case of
line out of operation.
To set the telephone line check, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press ▼ until the message below appears:
Then confirm by pressing
ENTER
.
4. The following message will appear on the display:
T e l . L i n e S U P E R V .
P h o n e N u m b e r P R G
C o m m u n i c a t o r P R G
E v e n t M e m o r y
P h . M o d e S e l x x
T e l . O p t . x x x x x x x x
P h o n e N u m b e r P R G
