Elkron MP120, Programming Manual

Page: 20 / 76

20/76
MP120
Control unit Expansion 1 Expansion 2 Expansion 3 Expansion 4
Input 02 > Output 02
Input 03 > Output 03
Input 04 > Output 04
Input 05 > Output 05
Input 11 > Output 11
Input 12 > Output 12
Input 13 > Output 13
Input 14 > Output 14
Input 21 > Output 21
Input 22 > Output 22
Input 23 > Output 23
Input 24 > Output 24
Input 31 > Output 31
Input 32 > Output 32
Input 33 > Output 33
Input 34 > Output 34
Input 41 > Output 41
Input 42 > Output 42
Input 43 > Output 43
Input 44 > Output 44
•
PO : the output is managed by the time programmer, the commands of which specify the output actuation and
deactivation times as well as from remote location, through DTMF tones (see user remote management).
•
Pre-actuation : the output is managed by the time programmer. The purpose of this is to actuate optical or
sound indicators in order to signal forthcoming automatic actuation of the system. It is actuated 5 minutes prior
to the actuation command given by the time programmer.
2.8.2 OUTPUT ENCODING TABLE
Every single output of the control unit (group 0) or expansions (groups 1, 2, 3, 4) is characterized by a 2-digit code:
the firs code identifies the device, whereas the second code identifies the input inside the device.
1
st
character Device 2
nd
character Output
0 Control unit 1 U1 - Output 1 *
1 Expansion 1 2 U2 - Output 2
2 Expansion 2 3 U3 - Output 3
3 Expansion 3 4 U4 - Output 4
4 Expansion 4 5 U5 - Output 5 **
* relay-type in the control unit, electric type in expansions - ** control unit only
Examples of encoding
04 = control unit output U4
21 = expansion 2 output U1
2.8.3 OUTPUT PROGRAMMING TABLE
No. Denomination Description U1 (control unit) U2, U3, U4, U5
(control unit)
U1, U2,U3, U4
(expansions)
01 Break-in Break-in alarm ♦ ■
02 Tampering Tampering alarm ■ ■
03 Robbery Robbery alarm (no sirens) ■
04 Panic Panic alarm ♦ ■
05 Technological Technological alarm ■
06 Fire Fire alarm ■ ■
07 Chime Chime (gong) signalling ■
08 Failure Generic failure alarm ■
09 Battery Low battery alarm ■
10 Network No mains supply alarm ■
11 Telephone line status Telephone line failure alarm ■
12 Reset Glass br smoke sensor reset ■
13 Buzzer Buzzer signalling ■
14 TC Correlated sector TC ■
15 System status System status STS ■
16 Open input Correlated sector open input (OI) ■
17 IN −> OUT Input-output direct connection ■
18 LPA LPA (alarm OR) ■
19 P.O. output Output managed both by PO and from
remote location (via DTMF)
■
20 Pre-actuation Pre-actuation signalling through PO ■
♦ Predefined alarm output (cannot be modified).
2.8.4 PROGRAMMING AN OUTPUT
To program an output, proceed as follows:
1. Type in the Installer code (factory setting: 000000), then press ENTER Twice.
2. The following message will appear on the display