17/76
MP120
7. The type of input will be displayed:
To modify it, press
ENTER
and choose another type by pressing button ▼, and confirm your choice by pressing
ENTER
again.
8. WARNING! IF THE INPUT IS NOT OF THE “BREAK-IN” OR “KEY” TYPE, GO TO STEP 10.
Press ▼. The list of the sectors to which the input is correlated will appear on the display.
To modify it, press
ENTER
and then type in the numbers of the sectors to be correlated (by typing in the number
of a sector already correlated, its correlation will be eliminated: the dash indicates a non-correlated sector). To
correlate it to all the sectors, press
TOTAL
. End the procedure by pressing
ENTER
again.
9. WARNING! IF THE INPUT IS NOT OF THE “BREAK-IN” TYPE, GO TO STEP 10. Press ▼. The input operation
mode will appear on the display:
To modify it, press
ENTER
and choose another type by pressing button ▼, then confirm your choice by
pressing
ENTER
again.
10. Press ▼. The “Chime” property setting will appear on the display:
To modify it, press
ENTER
and choose the setting by pressing button ▼, then confirm your choice by pressing
ENTER
again.
11. Press ▼. The uncoded input name (or a number of dots, if the input is not available) will appear on the display:
12.
To modify it, press
ENTER
and use the keyboard to enter the new extended name up to 8 characters (to enter
alphanumeric characters by means of the keyboard, refer to paragraph
2.2 ENTERING ALPHANUMERIC
CHARACTERS THROUGH THE keyboard
). End the procedure by pressing
ENTER
. It is recommended that a
descriptive name is assigned to the inputs (e.g. kitchen, hall, room, etc.) in order to facilitate recognition at a
later time.
13. Press
ESC
to go up one level in the menu.
14. Press ▼ to go to the next input to be configured (start again from step 6), or press
EXIT
to exit the menu.
2.7.5 PROGRAMMING THE EXPANSION AUXILIARY INPUT
The expansion auxiliary input may be programmed in two modes:
•
generic failure input;
•
signalling the lack of network voltage (230 V~) to the local power supply.
Warning! The “Prog.INo.aux EXP” menu item will appear only if connected expansions are available.
To program an auxiliary input, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The message below will appear on the display:
Press ► until the following message appears:
C o n t r . P a n e l P R G
E v e n t M e m o r y
0 1 : N a m e : . . . . . . . .
0 1 : G o n g : N O C h i m e
0 1 : M o d e : D e l a y e d
0 1 : S e t . : 1 2 3 4 5 6 7 8
0 1 : T y p e : B u r g l a r y
