65/76
MP120
3.11.4 KEY CHECK
It allows you to check the name assigned to a key and the sectors on which the key has been enabled to operate.
To check a key, proceed as follows:
1. type in the Master code or the Installer code, then press
ENTER
twice.
2. The following message will appear on the display:
Use button ▼ to select the following menu:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Use button ▼ to select the following menu:
Then press
ENTER
to confirm. The following message will appear on the display:
The system status LED of all the inserters will start blinking slowly.
4. Insert the key into an inserter (or move the transponder key near an inserter transponder). The display will
alternately show the following:
•
key number and name;
•
key number and correlated sectors.
If the key code does not correspond to any of the stored codes, all the inserter LEDs will blink fast, and the
«Unknown key!» message will appear on the display.
5. Repeat the procedure by starting from step 4 to check other keys, or press
ESC
several times to exit the menu.
3.11.5 ERASING ALL KEYS
To erase all the stored keys from the control unit, proceed as follows:
1. type in the Master code or the Installer code, then press
ENTER
twice.
2. The following message will appear on the display:
Use button ▼ to select the following menu:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Use button ▼ to select the following menu:
Then press
ENTER
to confirm.
D e l e t e A l l K e y s ?
R e a d N e w k e y
K e y P r o g r a m m i n g
E v e n t M e m o r y
I n s e r t K e y
K e y V e r i f i c a t i o n
R e a d N e w K e y
K e y P r o g r a m m i n g
E v e n t M e m o r y
