98
FAP54 Programming
RESTORE DEFAULT VALUES
[1] YES
[2] # NO
[OK] STORE CONFIGURATION
[ESC] EXIT WITHOUT STORING
PROGRAMMING DONE/FAILED
Press key
4
to restore the factory values in the device configuration.
To reset default values press
1
.
The active option is signalled by # symbol.
With
OK
you confirm selection. With
ESC
you go back to the previous menu without changing the current state.
The factory settings values of the programming parameters are listed below:
REPETITION ACTIVE:
YES
LED ACTIVE:
YES
FREQUENT BLINKING:
YES
3.7.3.13 Save configuration
After setting the device configuration parameters described in the previous paragraphs, press
ESC
in the device main
configuration menu and the following message will be displayed:
Therefore, the user can choose whether to implement the changes made up to that moment or cancel everything,
keeping the old device configuration.
If the user decides to store configuration, the following message will communicate the programming outcome:
Please note that the above mentioned device configuration is stored only in the device under consideration, but it
does not affect the data in the circuit module and the control panel.
Also note that when the type of device is changed (which can occur for MU, LI, PI groups), all the parameters (delay,
operating modes, etc.) of the device which has been assigned a new type are restored from the factory values.
Summary of Contents for FAP54
Page 151: ...FAP54 Programming 151 ...
