Elkron FAP54, Programming Manual

Page: 32 / 152

32 FAP54 Programming
CIRCUIT: XX
[1] SET SINGLE CIRCUIT IN LOOP MODE
[2] SET SINGLE CIRCUIT IN OPEN MODE
CIRCUIT: XX
TYPE: XXXX
DEVICE: YYY
TYPE: SM
CONFIGURATION STORED
[1] DELELE ALL THE ASSOCIATIONS
[2] DELETE EXPIRED ASSOCIATIONS
[ESC] BACK
3.1.3 Manual circuit configuration
Enter the circuit number and confirm with OK :
Then select the circuit configuration:
The following message will be displayed:
It shows:

the circuit being initialized

the circuit configuration
o
OPEN/LOOP if the user, in the previous step, did NOT change configuration
o
OPEN => LOOP if the circuit was previously configured as OPEN and now the LOOP configuration
has been selected
o
LOOP => OPEN if the circuit was previously configured as LOOP and now the OPEN configuration
has been selected

the generic device

the type of device
Through this menu it is possible to assign a type to each device.
Through keys

and

it is possible to select the device number, through keys < and > it is possible to select the type
to be assigned to the device.
To remove an already existing device or to cancel a wrong selection, select “—“.
After setting all the required devices, press OK to store the new configuration.
At the end of storage, the user can cancel completely all the associations or only those no longer valid (consider the
remarks made for the configuration of all lines):
By pressing ESC at any time, you will stop the procedure and reset the original configuration.
It is possible to change the configuration of a line without initializing it. To carry out this operation, select the line
configuration (LOOP/OPEN) and then press OK in the device type setting menu without changing any existing device.
It is possible to change the type of device on the detection line, even if physically it is different from the programmed
device.
It is not possible to change the type of device if it is excluded .