Eiki MCD-100, Owner'S Manual

Page: 68 / 96

68
10. PJ Controller
2. Check the status of the projector
The following items can be checked on the Power & Status screen.
Parameter Description
Accumulated lamp-use time............Displays accumulated time of lamp use in hour increment.
Accumulated projector-use time ....Displays accumulated time of projector use in hour increment.
Power Status ..................................Displays the status of the projector's lamp as follows:
On, Standby, On cooling down, Power Saver Mode/On cooling
down, Temperature Error/On cooling down, On starting up,
On power management operating, Temperature Error/Standby
Projection Condition ........................Displays the projector's condition as follows:
Normal, Temperature Error, Power Failure
Input Status ....................................Displays the following input status
Input............................Displays selected input mode.
Selection ....................Displays selected input source mode.
Signal Status ..............Displays signal status.
Internal Temperature ......................Displays detected internal temperature of the projector.
The icons A, B and C stands for the thermal sensors inside the
projector. If the internal temperature exceeds the certain point, each
icon changes as below and let users know the error. Check the air filters
and surrounding area of exhaust and intake vents of the projector.
Icon A, B and C are located as follows:
A: Ambient temperature of the projector
B: Ambient temperature of the
C: Ambient temperature of the lamp
* The ambient temperature of the projector may be shown a little higher than
the actual temperature.