Eiki MCD-100, Owner'S Manual

Page: 90 / 96

90
12. Appendix
If you have any trouble in setup or operation of the MCI, refer to the troubleshooting below and
check the relevant matters described.
Troubleshooting
■
MCI Client computer cannot detect projectors.
Make sure that Wireless or Wired is selected from the input source menu of the projector.
Does the message "Waiting For Connection" appear on screen?
No ........ The MCI is not attached to the projector properly.
Check the following matters:
*Is the POWER indicator of the MCI lighting?
*Is the indicator of the wired/wireless LAN card lighting?
->Check if the LAN card is inserted correctly into the MCI.
*Is the LAN cable connected to the wired LAN card properly?
->Check the setting on 4. Installation, 6. Wired LAN Configuration or 7.
Wireless LAN Configuration.
Yes ......LAN setting is not correct. Check the following matters.
■
Connection between PC and the projector via wireless LAN cannot be established.
AdHoc Mode:
When selecting LAN3(factory default setting)
Check each item in the Wireless Setting menu of the projector as follows:
*IP Address ..........Is the address appropriate? Should not be same as the other IP
address.
*Sub net ................Should be the factory default value, 255.255.255.0.
*Gateway ..............Should be the factory default value, 255.255.255.255
*Connection Status....Should be Ad-Hoc mode
*ESSID/SSID/IBSSID
..................................Should be same as the setting of the MCI Client
->Check the setting for the MCI Client
*Is the wireless channel set as 11?
->The factory default channel of the MCI is 11.
*ESSID/SSID/IBSSID should be same as the projector.
*WEP (Wired Equivalent Privacy)
..................................Should be disabled.
->To enable the function, set WEP at the web browser after the
connection is established. (Refer to 8. Configuration with Browser)