Eiki MCD-100, Owner'S Manual

Page: 38 / 96

38
7. Wireless LAN Configuration
5. Press SELECT button to complete the configuration.
1. Start up the MCI Client on your computer.
MCI Client starts to search MCIs. If configured projectors are shown on the window of the
MCI client, your computer is properly connected to the projectors via wireless LAN. If
" Troubleshooting" dialog appears, your computer is not connected to projectors. Check the
message on the "Troubleshooting" screen and search again.
Parameters and Descriptions
Checking the Operation
Check the configuration is successfully completed and the operation of the wireless LAN connection.
Parameter Description
IP Address
..........................
Set the IP address in the environment you wish to use.
Sub Net ..............................Set the Subnet mask in the environment you wish to use.
Gateway..............................Set the gateway address in the environment you wish to use.
*
If any segment beyond the router is not used, the gateway address can be left
at “255.255.255.255”.
Connection Status ....Set this status in accordance with the communication mode
(Infrastructure or AdHoc) you wish to use.
SSID/ESSID/IBSSID ....In both Infrastructure and AdHoc mode, same charactered have to be
set to the MCI, access point and the wireless-enabled computer.
( up to 32 characters) Be cautious when entering the characters, since
SSID/ESSID is case-sensitive.
To set "ANY" for the MCI is not recommended.
Error Screen Main Screen
Search button
※
IP address can be set using "arp + ping" command. (See P94)
Window