![background image](http://html1.mh-extra.com/html/eaton/easy800/easy800_manual_3950236314.webp)
8 800 Settings
8.2 System
310
Control Relay easy800
11/11 MN04902001Z-EN
www.eaton.com
Alternatively you can select the Retain markers during transfer option in
easySoft-Pro.
▶
Save the entry from .. to .. with OK.
Press ESC to exit the input for the retentive ranges.
8.2.6.2 Deleting areas
Set the ranges to be erased to the values from 00 to 00.
Example: MB 00 -> MB 00. The markers are no longer retentive.
Deleting retentive actual values of markers and function blocks
The retentive actual values are cleared if the following is fulfilled (applies only
in STOP mode):
•
When the circuit diagram is transferred from easySoft-Pro (PC) or from
the memory card to the easy800 device, the retentive actual values are
reset to 0. This does not occur if you have selected the Retain markers
during transfer option in easySoft-Pro or activated the RETAIN MARKERS
option on the device. easy800-SWD does not have this option..
•
When changing the respective retentive range.
•
If the set retentive ranges are reduced, only the actual values that are
outside of the new range are deleted.
•
When the circuit diagram is deleted via the DELETE PROG menu.
The retentive actual values are retained in easy800 on:
•
Changing the operating mode
•
Changing the circuit diagram
•
Relays no longer used
•
Changing from RUN to STOP
•
Changing the startup behaviour in the SYSTEM menu
•
Expanding the retentive range
8.2.6.3 Transferring retentive behavior
The retention setting is a circuit diagram setting and is carried with the
program when it is transferred from the memory card or from easySoft-Pro.