![background image](http://html1.mh-extra.com/html/eaton/easy800/easy800_manual_3950236302.webp)
8 800 Settings
8.1 Password protection
298
Control Relay easy800
11/11 MN04902001Z-EN
www.eaton.com
▶
Press OK to save the new password.
Use OK to exit the password display and proceed with ESC and
Ú
to the
RANGE… menu. You can define here which area you wish to protect with
the password.
Protecting special areas
▶
Press OK.
▶
Select the function or the menu to be protected.
▶
Press the OK in order to protect the function or the menu
(
å
= protected).
•
CIRCUIT DIAGRAM: The password is applied to the circuit diagram as
well as function blocks that are not enabled. This area also prevents the
transfer of a circuit diagram from and to the memory card.
•
PARAMETER: The PARAMETER menu is protected.
•
CLOCK: Date and time are protected with the password.
•
MODE: It is not possible to change the operating mode from RUN to
STOP operating mode and vice versa using the function keys of the
device concerned. The same applies for the Run/Stop buttons of
easySoft-Safety.
•
INTERFACE: Protects against access to the multi-function interface of
this device. Data exchange via the easyNet is not affected. Take into
account the restricting effect of a protected interface if you have to reset
the easy800 device to factory settings (
known or incorrect“, Page 301).
•
DELETE PROGRAM: When this function is not activated, the question
“DELETE PROG?” will appear if the password entry is entered
incorrectly four times. This question does not appear if you activate this
function and protect the DELETE PROGRAM area. However, it is no
longer possible to make changes in protected areas if you forget the
password.
The password is now valid but not yet activated.
ENTER PASSWORD
000042
Circuit Diagram
åÆ
PARAMETER
CLOCK
INTERFACE
DELETE FUNCTION
→
At least one area must be protected. In the default setting the
circuit diagram is selected.
DANGER
This password protection does not prevent operating mode
changes in the following cases:
•
With REMOTE RUN activated the NET station 2-8 follows
the operating mode change of the NET station with
NET-ID 1,
Section “Description of the NET-
PARAMETERS“ ->„Automatic change of the RUN and
STOP mode (Station Menu REMOTE RUN)“ on Page 280.
•
Operating mode changes can also be triggered through local
expansion units (communication modules).