DURKOPP ADLER 911-211-10, Operating Instructions Manual

Page: 116 / 134

Troubleshooting
114 Operating Instructions 911-211-10 - 00.0 - 10/2020
2355 Stroke position stepper motor overload
• Feed system not moving freely
• Obstacles to the feed motion • Eliminate sluggishness
• Remove obstacles/adjust the motion
2356 Stroke position stepper motor
overtemperature
• Feed system not moving freely
• Stepper motor faulty
• Control defective
• Eliminate sluggishness
• Replace stepper motor
• Replace control
Machine control
3100 Machine control voltage
• Temporary mains voltage
interruption
• Check mains voltage
3102 Machine voltage in sewing motor
intermediate circuit
• Temporary mains voltage
interruption
• Check mains voltage
3103 Machine voltage in stepper motor
intermediate circuit
• Temporary mains voltage
interruption
• Check mains voltage
3107 Machine temperature
• Ventilation openings closed
• Ventilation grille dirty
• Clean ventilation grille
• Check ventilation openings
3109 Threading mode is switched on Switch off threading mode
3121 Compressed air is missing, not
sufficient Turn up air pressure and stabilize
3123 Oil sensor active Top off the oil
3210 Thread broken Re-thread the thread
3215 Bobbin empty (remaining thread
counter) Insert full bobbin
3220 Bobbin empty (remaining thread
counter) Insert full bobbin
3500 Error in calculating the contour data • Reload the contour data
• Check the contour data
3501 Target position of the XY clamps
outside the motion limits Adjust the contour data
3502 Target position of the XY clamps within
the "forbidden areas" Adjust the contour data
3721
3722 Internal error • Switch off and on the machine
• Software update
• Notify DA Service
4201 Internal CF card defective • Switch off and on the machine
• Retrofit/replace control
5301 Program cannot be sewn Copy program to DAC
Error
code
Description Troubleshooting