Docomo N-04A, Instruction Manual

Page: 59 / 570

57 Continued on next page
V
oice/Vid
eophone Calls
● If a videophone call is not connected
When a videophone call is not connected, the cause
of the failure appears.
z
The cause may not appear depending on the
situation.
z
Depending on the type of other party’s phone or the
possible lack of a network service subscription, the
reason may not accurately reflect the other party’s
actual status.
z
If the videophone call is not connected, your call is
automatically switched to a voice call when you set
“Auto redial as voice” to “ON”. However, the call
may not be handled in this way if you call an ISDN
synchronous 64K access point, ISDN videophone
which does not support the 3G-324M standard (as
of December, 2008) or if you dial a wrong number.
Note that call charge may be applied in some
cases.
Switching a Voice/
Videophone Call during a Call
(Caller)
z
You can use this function with the terminals
compatible with voice call/videophone call switch.
z
You can switch the voice call only when you are the
caller.
z
To switch the call, the receiver needs to set “Ntfy
switch-mode” to notify the switch beforehand.
→ P.75
<Example: To switch a voice call to a videophone
call>
1 In-call screen (P.54)
d
(V.phone)
“YES”
While switching, the screen which indicates that
the calls are being switched appears and the
voice guidance is played.
Display Cause
Check number
then redial The called phone number is
not used
Busy The line is busy
• This message may also
appear during packet
communication.
Busy with packet
transmission The other party is using
packet communication
Out of service
area/power off The other party is out of
service area or the phone is
turned off
Your call is being
forwarded The call is being forwarded (A
Videophone call is made
when the forwarding number
is for a 3G-324M-compatible
videophone)
Redial using voice
call The phone for the forwarding
number is not compatible with
videophone calls
Please activate
caller ID before
dialing again The other party sets the
Caller ID request service
This number is not
available. The other party sets the
Nuisance call blocking
service
Upper limit has
been exceeded
Connection failed The upper limit set for a Limit
billing plan (Type Limit and
Family Wide Limit) is
exceeded
Connection failed You connected without
notifying your caller ID (when
dialing into visualnet, etc.)
• This message may also
appear in other situations
Set the caller ID notification
to “ON” and retry
Please make your
call from the
i-mode web page You attempted to make a
videophone call to watch
V-live without browsing the
i-mode official site
The digital communication
fee is charged after the
appearance of this screen.